I'm using ocad to set a relay but I can't figure out how to make the 3rd and 4th legs run in directions different from 1 & 2. I'm missing something...can anybodyhelp?
Ask the JWOC organisers, they're experts.
Did you check the How To regarding relay course setting on the ocad homepage:
http://www.ocad.ch/en/howtos.htm
I think this would answer your question.
OCAD requires individual site licenses; the condes license is club-wide.
Why would anyone prefer OCAD over condes for course design?
Because I already have 0CAD, and it works fine for my purposes?
(Thanks, mikee, for finally answering Linda's question.)
That's about the ONLY reason I could think of. If people without OCAD need to work with the file(s), then it's a problem.
The OCAD Help tip helps...will keep working on it.
You can purchase OCAD course-setting without mapping capability if you so desire, for a lot less than the full version.